Sea Ray 290 Sundancer Manual do Proprietário Página 86

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 150
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 85
6.12
SECTION 6 • ELECTRICAL SYSTEM
290 Sundancer
®
10. SHORE POWER
A. SHORE POWER CORDS
The 290 DA is equipped with a 30AMP/ 120V/60
cycle shore power cord for hookup to dockside
power. The cord is stored in the transom storage
box.
B. MAIN SHORE POWER BREAKER BOX
The 290 DA is equipped with a 120VAC main shore
power breaker box located on the starboard side of
the transom storage box.
The breaker must be ON to operate the shore AC
power system.
C. SHORE POWER
The 120 volt AC main distribution panel distributes
the required voltage for all the boat’s AC equipment
and accessories. It is very important to know and
understand where the power originates and how
the power is distributed to the different voltage
equipment and accessories.
To access the shore power see “Shore Power” in
Section 3 - Using Your Boat.
11. GENERATOR (OPTIONAL)
Sea Ray
®
strongly urges you to fully comply with
the manual provided by the generator manufacturer.
The generator is warranted separately by the
generator manufacturer, NOT Sea Ray
®
. Follow
the recommended maintenance and warranty
schedule in your Generator Operator’s Manual
included in the Owner’s Manual Packet. Generator
abuse or improper maintenance may adversely
affect claims made under generator manufacturer
separate warranty.
The generator is located in the bilge starboard of
the fresh water tank.
A. GENERATOR OPERATION
The procedures for starting, stopping and switching
between generator and shore power are explained
in Section 3 - Using Your Boat, pages 3.7 - 3.10.
Do not run the generator in an enclosed area,
such as a closed boathouse, as there is a
possibility of buildup and inhaling of carbon
monoxide.
! CAU TION
12. SERVICING THE MAIN
DISTRIBUTION PANEL
NOTE: Servicing should be referred to a qualifi ed
electrician.
A. TO REPLACE A FAULTY COMPONENT ON
THE MAIN DISTRIBUTION PANEL:
1. Turn all breakers OFF.
2. Unplug the shore power.
3. Remove screws from all sides except the
hinged side of panel. The main distribution
panel is hinged to swing open for servicing.
4. Reverse the procedure for closing the panel.
Disconnect the power cable from power source before
performing maintenance.
! WARNING
13. BATTERY CHARGER/CONVERTER
The battery charging unit located on the bilge
component board is fully automatic and is designed
specifi cally for the marine environment. The high
frequency characteristic has allowed these chargers
to achieve a huge size and weight reduction over
previously used equipment. Commonly called high
frequency or smart chargers, these units bring a
new sophistication to the battery charger fi eld.
Vista de página 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 149 150

Comentários a estes Manuais

Sem comentários