Sea Ray 290 Sundancer Manual do Proprietário Página 56
- Página / 150
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
3.8
SECTION 3 • USING YOUR BOAT
290 Sundancer
®
11. STOPPING THE GENERATOR
1. Prior to generator shut
down turn OFF all AC
equipment and breakers
including main breakers
and allow the generator
to run a few minutes to
cool down.
2. Stop the generator by quickly depressing and
releasing the START/STOP switch.
REFER TO THE GENERATOR MANUAL FOR YOUR
BOAT IN THE OWNER’S MANUAL PACKET.
12. SHORE POWER
A. TO CONNECT AND TURN ON SHORE POWER
1. On the Boat: Turn OFF All Breakers
A. Turn OFF equipment breakers
B. Turn OFF SHORE break er
C. Dry off the shore power
cord receptacle on your
boat. Dry off the ends of
the shore power cord,
and spray a moisture
repellent into the recep-
tacle and cord ends.
On the boat, plug
the cord end into the
boat receptacle. Turn
clockwise to lock. Thread the locking ring
onto the boat receptacle to prevent accidental
unplugging.
D. The AC Main Shore
Power Breaker, located
forward of the shore
power receptacle must
be ON at all times to
operate the shore AC
power system.
It is imperative that the shore power outlet is dry
before plugging into the dock power inlet.
! CAUTION
SHORE POWER
RECEPTACLE
(FIG. 3.8.2)
C
Route and tie the power cord from the boat to the
dockside power outlet box to prevent persons
tripping over it and the cord falling in the water.
! CAU TION
12 VOLTS DC
120 VOLTS AC
GENERATOR
SHORE
0
AC VOLTS
50
100
150
OUTLETS/
REFRIGERATOR
MICROWAVE
WATER HEATER
REFRIGERATOR
CABIN LIGHTS
FRESH WATER
PUMP
CO MONITOR
POWER
REVERSED
POLARITY
BATTERY
CHARGER
STOVE
AIR
CONDITIONER
STEREO
SYSTEM
HEAD
SYSTEM
TV/12V
RECEPTACLE
ACCESSORY
MAIN DISTRIBUTION PANEL (MDP) (FIG. 3.8.1)
Note: The power panel on your boat may not look exactly like this one.
120 VAC
B
A
A
Shore power cord should be secured or routed
to avoid laying or falling into water and to avoid
stress on shore power plug and inlet.
! CAU TION
The use of extension shore power cords is not
rec om mend ed. Excessive power cord ex ten sions
can cause a voltage drop and may prevent some
electronic devices from operating correctly.
! CAUTION
AC MAIN SHORE
POWER BREAKER
(FIG. 3.8.3)
D
- 290 Sundancer 1
- HIS MANUAL 5
- OUR RESPONSIBILITIES 5
- OURCES OF INFORMATION 5
- INTRODUCTION 6
- ERVICE, PARTS AND REPAIR FOR 7
- OUR BOAT 7
- ABOUT YOUR LIMITED WARRANTY 8
- NTRODUCTION 9
- ECTION 3 • USING YOUR BOAT 9
- ECTION 5 • FUEL SYSTEM 10
- ECTION 6 • ELECTRICAL SYSTEM 10
- AINTENANCE 11
- SECTION 1 • SAFETY 13
- ECTION 1 • SAFETY 22
- E. COLLISIONS AND LEAKING 24
- F. GROUNDING 24
- 22. WARNING LABEL LOCATIONS 29
- WARNING LABEL LOCATIONS 30
- (FIG. 1.18.1) 30
- ARNING LABEL LOCATIONS 31
- IG. 1.19.1) 31
- DO NOT CLIMB UPON OR STORE 31
- EQUIPMENT ON HARDTOP 31
- 1. DOCKING/ LIFTING/ STORAGE 33
- 2. PASSENGER LOCATIONS 34
- ! DANGER 35
- 3. PROPULSION SYSTEM 36
- (FIG. 2.5.1) 37
- 290 SUNDANCER 37
- 5. DECK LAYOUT 38
- 6. CABIN LAYOUT 39
- (FIG. 2.8.1) 40
- (FIG. 2.8.2) 40
- WITCH PAD 41
- IG. 2.9.1) 41
- IG. 2.9.2) 41
- HELM LAYOUT (FIG. 2.10.1) 42
- ! CAUTION 44
- B. POWER TRIM UNIT AND GAUGE 44
- TTITUDE LIST PUSH 45
- 10. IMPORTANT GAUGES 46
- (FIG. 2.15.1) 47
- SECTION 3 • USING YOUR BOAT 49
- 1. BILGE 59
- D. BILGE BLOWER 60
- 2. ENGINE AND STERN DRIVE 61
- SELECTION 62
- 3. UNDERWATER GEAR 63
- 4. SEACOCKS & STRAIN ERS 64
- 5. BILGE LAYOUT 66
- B ILGE LAYOUT (CONT.) 67
- SECTION 5 • FUEL SYSTEM 69
- O REPLACE THE FILTER: 72
- B. GENERAL: 72
- UELING PRECAUTIONS 72
- SECTION 6 • ELECTRICAL SYSTEM 75
- LECTRONIC INTERFACE MODULE 79
- IG. 6.5.1) 79
- IG. 6.5.2) 79
- BULB#CEC1141 83
- BULB#T125 83
- A. INTERNATIONAL RECEPTACLE 88
- IG. 6.14.1) 88
- LECTROLYTIC CORROSION AND 88
- INC ANODES 88
- LECTRICAL SCHEMATICS 91
- IRING DIAGRAM (1 OF 8) 91
- IRING DIAGRAM (2 OF 8) 92
- IRING DIAGRAM (3 OF 8) 93
- IRING DIAGRAM (4 OF 8) 93
- IRING DIAGRAM (5 OF 8) 94
- IRING DIAGRAM (6 OF 8) 94
- IRING DIAGRAM (7 OF 8) 95
- IRING DIAGRAM (8 OF 8) 96
- . 6.23.1) DRAWING NO. 09-605 97
- ABIN DC WIRING DIAGRAM 98
- TEREO SYSTEM SCHEMATIC 99
- ATELLITE STEREO DIAGRAM 108
- ORTHSTAR 6000I SYSTEM DIAGRAM 108
- NTERCONNECT DIAGRAM 109
- OLVO SYSTEM DIAGRAM 110
- ILGE HARNESS 111
- ENERATOR HARNESS 113
- ABIN HARNESS 114
- REMIER STEREO HARNESS 115
- POILER HARNESS 116
- 2. CARBON MONOXIDE MONITOR 117
- (OPTIONAL) 117
- 4. WATER SYSTEM 118
- B. WATER PUMP AND FILTER 119
- D. SHOWER SYSTEM 120
- E. TRANSOM SHOWER 121
- F. DOCKSIDE WATER INLET 121
- ! WARNING 121
- 6. HEAD SYSTEM 122
- B. VACUFLUSH 123
- C. HOLDING TANK OPERATION 123
- D. VENT FILTER 123
- 7. MACERATOR DISCHARGE PUMP 124
- SEACOCK INTERLOCK SYSTEM 124
- A. GASOLINE ENGINE BOATS 125
- B. DIESEL ENGINE BOATS 125
- 9. EN TER TAIN MENT SYSTEM 126
- 10. REFRIGERATOR 127
- 11. CANVAS 127
- 12. HORN 128
- 13. SPOT LIGHT (OPTIONAL) 128
- 14. UNDERWATER LIGHTING 128
- INTERVAL 130
- SEFUL SERVICE INFORMATION 131
- 3. INSPECTION, SERVICE AND 132
- PROTOCOL 132
- BOATS STORED ON LAND 133
- D. HEAD SYSTEM 134
- E. WATER SYSTEM 134
- F. FUEL SYSTEMS 134
- 6. SECURITY CONSIDERATIONS 135
- 5. FITTING OUT AFTER STORAGE 135
- 7. SEACOCK LUBRICATION 136
- UICK REFERENCE CHECKLIST 137
- A. BOARDING THE BOAT* 137
- OAT SYSTEMS 137
- C. WHILE UNDERWAY 139
- D. RETURNING TO PORT 139
- E. SECURING THE BOAT 140
- AINTENANCE LOG 142
- 2. FIBERGLASS AND GELCOAT 143
- 1. PAINT CLEANING AGENTS AND 143
- OTHER SUBSTANCES 143
- B. SALT CRYSTALS 144
- ANVAS AND CLEAR VINYL 145
- CRYLIC PLASTIC SHEETING 145
- LASTIC GLASS) 145
- AUGE AND SWITCH PANELS 145
- XTERIOR UPHOLSTERY FABRIC 146
- NTERIOR UPHOLSTERY FABRIC 146
- Index iv 150
Manuais e produtos relacionados com Geradores de energia Sea Ray 290 Sundancer
(67 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.018 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais